Correct Use Of Heat-shrinkable Tube Method And Material Introduction

- Dec 20, 2017-

The heat shrinkable tube is heated by the heat shrinkable pipe collectively, material and temperature resistant degree can be divided into PTFE, FEP heat shrinkable tube heat shrinkable tubes, PVDF heat shrinkable tube, PVC heat shrinkable sleeve, heat shrinkable tube, PET PE irradiation cross-linked heat shrinkable sleeve, heat shrinkable tube, 10KV high voltage busbar protection 35KV high voltage busbar protection thermal shrinkage sleeve, glue double wall heat shrinkable sleeve, heat shrinkable casing graining.

The bare bus distribution cabinet in the need to install heat shrinkable tube, usually in the factory installed in at the same time, equipment components installed in distribution cabinet, the heat shrinkable tube is sleeved in advance on the bus, after all the components installed, the screw has been fastened, Guan Puping will shrink, put in place, air heater will heat shrinkable tube can be on the bus. The oven can also be used as a batch heat shrinkable. The oven is set according to the material characteristics of the heat shrinkable tube, and the heat shrinkable tube is first United on the online beam link point, and then the batch is put into the oven to complete the insulation protection for the connection point.